Sam Bloomberg
@xbloom.io
Principal Gameplay Engineer at 1047 Games (Splitgate 2)
Formerly Xbox/SQTech/343i
Formerly Xbox/SQTech/343i
Since I expected to have to occasionally re-flash the board as I inevitably broke something, I designed the enclosure in two pieces: a mount for the touchscreen/board, and a magnetic wall plate that it would attach to.
November 24, 2024 at 6:16 PM
Since I expected to have to occasionally re-flash the board as I inevitably broke something, I designed the enclosure in two pieces: a mount for the touchscreen/board, and a magnetic wall plate that it would attach to.
The enclosure is a simple 3d-printed mount that I drew up in Solid Edge - I haven't done any CAD work before so this was a fun learning experience. I made way too many revisions of the board as I slowly learned a good workflow to designing around physical constraints.
November 24, 2024 at 6:16 PM
The enclosure is a simple 3d-printed mount that I drew up in Solid Edge - I haven't done any CAD work before so this was a fun learning experience. I made way too many revisions of the board as I slowly learned a good workflow to designing around physical constraints.
So I did! This is an adafruit ESP32-S3-based board hooked up to a 4" 480x480 TFT touchscreen. OpenHASP didn't support this board out of the box, so it's running a lightly modified distribution that took me a while to figure out how to get running.
November 24, 2024 at 6:16 PM
So I did! This is an adafruit ESP32-S3-based board hooked up to a 4" 480x480 TFT touchscreen. OpenHASP didn't support this board out of the box, so it's running a lightly modified distribution that took me a while to figure out how to get running.