34. Ghost in the Shell.

Looks good as a face replacement for an off the shelf clock too!!

Clock face looks as expected. Next step is to print the the body

The failed print was completely warped. It might be a good idea to get a new printing surface (smooth or satin), as I'm using the stock textured sheet I received with the printer 4 years ago

Bes was cleaned with soap and warm water before printing. I cheched the first few layers before going to bed and everything seemed fine. I’ll inspect the part for warping or other issues. I think the nozzle may be getting caught on the piece due to overextrusion

Everything was not ready to print. A few small parts printes flawlessly, but the cover for a gridfinity case failed. This afternoon I’ll check the failed part and try again. Maybe it’s a good time to finally try to fix the slight overextrusion issue my printer has

As it seems It'll take a while to release I added a category to my budget to be ready when the kit drops :D

Está todo inquietantemente tranquilo, si