Peter Pak
LightNews LightNews
ppak.net
Peter Pak
@ppak.net
5 followers 4 following 66 posts
I like building stuff
Posts Replies Media Videos
ppak.net
First SLS Benchy prints on the Inova
October 9, 2025 at 2:32 PM
ppak.net
First successful print on the Inova Mk1 with Formlabs PA12 GF powder.
October 8, 2025 at 3:23 AM
ppak.net
After paint
July 29, 2025 at 7:46 PM
ppak.net
July 29, 2025 at 7:05 PM
ppak.net
Janghoon’s Centerpiece
July 29, 2025 at 7:05 PM
ppak.net
1/2” 6-32 screws with spacer for top center piece fixture holders
July 29, 2025 at 7:00 PM
ppak.net
Cut with the 1/8” end mill was a bit too deep on the pocket and left some burrs behind. Will need to move it up just by. A little to avoid using scotch brite to clean up
July 16, 2025 at 7:50 PM
ppak.net
#2 center drill doesn’t seem to hit #op1
July 14, 2025 at 7:40 PM
ppak.net
Retract could be faster #op1
July 14, 2025 at 7:39 PM
ppak.net
July 14, 2025 at 7:37 PM
ppak.net
July 14, 2025 at 7:37 PM
ppak.net
Chamfering could be a little bit lower to avoid burrs
July 14, 2025 at 7:37 PM
ppak.net
Making bases again, facing op is alright
July 14, 2025 at 7:32 PM
ppak.net
@gitlab.com Why GitLab?

about.gitlab.com/why-gitlab/
It's back up now but thought it was funny when I first encountered it.
GitLab's "Why GitLab" page crashes with a 500 Error
June 24, 2025 at 7:11 PM
ppak.net
May 1, 2025 at 11:19 PM
ppak.net
And now it works!
May 1, 2025 at 11:19 PM
ppak.net
Put in a new one
May 1, 2025 at 11:19 PM
ppak.net
Yeah, that’s the problem
May 1, 2025 at 11:19 PM
ppak.net
So then took a look at the pump, looks pretty rusted
May 1, 2025 at 11:19 PM
ppak.net
Though, that didn’t seem to fix the low pressure problem
May 1, 2025 at 11:19 PM
ppak.net
First thought the boiler was the issue, so looked into replacing that first
May 1, 2025 at 11:19 PM
ppak.net
Fixed my espresso machine today
May 1, 2025 at 11:19 PM
ppak.net
March 22, 2025 at 12:40 AM
ppak.net
One pass is sometimes good enough
March 22, 2025 at 12:40 AM
ppak.net
0.0005” depth cuts seem to work, though leaves burrs in the paint
March 21, 2025 at 11:11 PM