Mishka
LightNews LightNews
mishkaa.bsky.social
Mishka
@mishkaa.bsky.social
86 followers 210 following 510 posts
Tolerating gerontocracy, housing theory of everything understander, abundant housing, abundant transit.

Also computer and math stuff
Posts Replies Media Videos
mishkaa.bsky.social
How does North American math programs compare to ones in like Technion, ETH Zurich, Australia. Wonder if you looked this up
November 27, 2025 at 5:46 AM
mishkaa.bsky.social
So that's who Mr. Fight... The oligarchy is? Absolutely classic
November 26, 2025 at 5:24 AM
Reposted by Mishka
bubbaprog.xyz
again, this is a Europe regulations vs U.S. regulations thing! there are a total of five pages discussing the different beam strength at different wavelengths in the european standard, whereas the DOT says headlights must be "white."
Requirements for LED modules and Road Illumination Devices (except cornering lamps) including LED modules and/or LED light sources 1. General requirements for LED modules 1.1. Each LED module sample submitted shall conform to the relevant requirements of this Regulation when tested with the supplied electronic light source control-gear(s), if any. 1.2. LED module(s) shall be so designed as to be and to remain in good working order when in normal use. They shall moreover exhibit no fault in design or manufacture. A LED module shall be considered to have failed if any one of its LEDs has failed. 1.3. LED module(s) shall be tamperproof. 1.4. The design of removable LED module(s) shall be such that: 1.4.1. When the LED module is removed and replaced by another module provided by the applicant and bearing the same light source module identification code, the photometric requirements of the headlamp or AFS system shall be met; 1.4.2. LED modules with different light source module identification codes within the same lamp housing shall not be interchangeable. 2. Manufacture of LED modules 2.1. The LED(s) on the LED module shall be equipped with suitable fixation elements. 2.2. The fixation elements shall be strong and firmly secured to the LED(s) and the LED module. 3. Test conditions 3.1. Application 3.1.1. All samples shall be tested as specified in paragraph 4. 3.1.2. The kind of light sources on a LED module shall be light-emitting diodes (LED) as defined in paragraph 2.7.1. of UN Regulation 48 in particular with regard to the element of visible radiation. Other kinds of light sources are not permitted. 3.2. Operating conditions 3.2.1. LED module operating conditions All samples shall be tested under the conditions as specified in paragraph 4.6.4. of this Regulation. If not specified differently in this Annex LED modules shall be tested inside the device as submitted by the manufacturer. 3.2.2. LED light source operating conditions All samples shall be tested under the conditions as specified in paragraph 4.6.3. of this Regulation. 3.2.3. Ambient temperature For the measurement of electrical and photometric characteristics, the device shall be operated in a dry and still atmosphere at an ambient temperature of 23 °C ± 5 °C. 3.3. Ageing Upon the request of the applicant the LED module shall be operated for 15 h and cooled down to ambient temperature before starting the tests as specified in this Regulation. 4. Specific requirements and tests 4.1. Colour rendering 4.1.1. Red content In addition to provisions as described in paragraph 4.16. of this Regulation. The minimum red content of the light of a LED module or a device incorporating LED module(s) tested (at 50 V for headlamps and AFS) shall be such that: 0.05 E ( ) V( ) d E ( ) V( ) d k 780 n m 380 n m e 780 n m 610 n m e red             where: Ee() (unit: W) is the spectral distribution of the irradiance; V() (unit: 1) is the spectral luminous efficiency; () (unit: nm) is the wavelength. This value shall be calculated using intervals of one nanometre. 4.2. UV-radiation The UV-radiation of a low-UV-type LED module shall be such that: 10 W / lm k E ( ) V( ) d E ( ) S( ) d k 5 780n m 380n m m e 400n m 250n m e UV              where: S() (unit: 1) is the spectral weighting function; km = 683 lm/W is the maximum value of the luminous efficacy of radiation. (For definitions of the other symbols see paragraph 4.1.1.). 43.1.3. 43.1.4. 43.1.5. 5.1. 5.2. Calculate the ratio between the photometric test point value determined in paragraph 4.3.1.1. and the point value determined in paragraph 4.3.1.2. Once stability of photometry has been achieved, apply the ratio calculated above to each of the remainder of the test points to create a new photometric table that describes the complete photometry based on one minute of operation. The luminous intensity values, measured after one minute and after photometric stability has occurred, shall comply with the minimum and maximum requirements. Colour The colour of the light emitted measured after one minute and measured after photometric stability has been obtained, as described in paragraph 4.3.1.2., shall both be within the required colour boundaries. The measurement of the objective luminous flux of LED module(s) producing the principal passing-beam shall be carried out as follows: The LED module(s) shall be in the configuration as described in the technical specification as defined in paragraph 3.1.3. of this Regulation. Optical elements (secondary optics) shall be removed by the Technical Service at the request of the applicant by the use of tools. This procedure and the conditions during the measurements as described below shall be described in the test report. One module of each type shall be submitted by the applicant with the light source control gear, if applicable, and sufficient instructions. Suitable thermal management (e.g. heat sink) may be provided, to simulate similar thermal conditions as in the corresponding headlamp or AFS application. Before the test each LED module shall be aged at least for seventy-two hours under the same conditions as in the corresponding headlamp application. In the case of use of an integrating sphere, the sphere shall have a minimum diameter of one meter, and at least ten times the maximum dimension of the LED module, whichever is the largest. The flux measurements can also be performed by integration using a goniophotometer. The prescriptions in CIE - Publication 84 - 1989, regarding the room temperature, positioning, etc., shall be taken into consideration. The LED module shall be burned in for approximately one hour in the closed sphere or goniophotometer. The flux shall be measured after stability has occurred, as explained in paragraph 4.3.1.2. LOWER BEAM HEADLIGHTS NUMBER AND COLOR: White, of a headlighting system listed in Table II
November 25, 2025 at 12:30 AM
mishkaa.bsky.social
thought I was alone here
November 25, 2025 at 5:17 AM
mishkaa.bsky.social
November 22, 2025 at 3:46 AM
mishkaa.bsky.social
It's very important to me to piss off big left-NIMBY orgs like California Endowment. Also, it's still useful
November 21, 2025 at 8:45 PM
mishkaa.bsky.social
made a big mistake once telling this to an Armenian person
November 21, 2025 at 7:59 AM
mishkaa.bsky.social
that's the "why did you stop giving me scritches, hooman" look my goldendoodle gives me
November 21, 2025 at 6:01 AM
mishkaa.bsky.social
a young boy wearing a hat with the word angels on it is sitting in a crowd of people at a baseball game .
ALT: a young boy wearing a hat with the word angels on it is sitting in a crowd of people at a baseball game .
media.tenor.com
November 20, 2025 at 10:20 AM
mishkaa.bsky.social
take a guess

bsky.app/profile/mata...
matatoeslasagna.bsky.social Matatoes Lasagna @matatoeslasagna.bsky.social · 10d
Yeah and I'm sure that will have zero negative ramifications
November 19, 2025 at 6:34 AM
mishkaa.bsky.social
Yes, the emergency declaration is over. There's probably no elected official in LA that detests ED1 more than Bass herself at this point.
November 18, 2025 at 8:24 PM
mishkaa.bsky.social
ED1 btw, also literally ends today. Oh and btw our own city attorney fought against building those units.
November 18, 2025 at 5:59 PM
mishkaa.bsky.social
They're certainly betting on low turnout and in LA it's depressingly low
November 18, 2025 at 5:57 PM
mishkaa.bsky.social
I wear a headlamp at night that outputs more lumens than most car headlights. What else is one to do?
November 17, 2025 at 6:30 PM